» » »



The price is for a single unit not for a pair.

The floorstanding RS6 is a ported, bass-reflex design with two 6" C-CAM drivers for the bass and midrange reproduction. The 6" cones cast-polymer chassis help damp the residual energy produced by the movement of the drivers. In this two-and-a-half-way design, both 6" drivers contribute to the bass, but only the upper one extends into the midrange; it crosses over to the tweeter at 3kHz. The ports, one each on front and rear, help increase the weight of the low end. Should that bass weight prove too much, port plugs are included -- a nice touch that allows the user to fine-tune the speakers? sound to the room. I used them, as you?ll see below.

Monitor claims the Silver RS6s frequency response to be 38Hz-30kHz, its sensitivity an efficient 91dB, and its nominal impedance 6 ohms -- it should be relatively easy for an amplifier to drive. Monitor also says that the RS6 can handle up to 120W RMS of amplification, and suggests using an amp that can output at least 40Wpc.

The cabinet itself measures just 33 7/16"H x 7 1/4"W x 9 13/16"D; attaching the plinth adds an inch of height and expands the RS6?s footprint to 10"W by 12"D. Each speaker weighs about 35 pounds. Included are four sturdy, adjustable levelers that screw into the bottom of the plinth to couple the speaker to the floor.

Customers who bought this product also purchased
1GX288 230x280x80 mm
1GX288 230x280x80 mm
Quick Find
Use keywords to find the product you are looking for.
Advanced Search
1 x SP-80X
1 x Hw202
Manufacturer Info
Monitor Audio
Other products
Share Product
Share via E-Mail Share on Facebook Share on Twitter Share on Digg
italiano english